In libraryMXS 10 12V 10A Battery Charger and Maintainer
The CTEK MXS 10 is an 8-step, fully automatic battery charger and maintainer for 12V lead-acid batteries. It delivers 10A to batteries from 20-200Ah and can maintain larger batteries up to 300Ah. The charger includes battery diagnosis, a Recond mode, and an AGM option.
We earn a small commission on purchases through this link. It does not change what you pay and never affects ratings.
Safety notes for this component
- Always disconnect the mains cable before connecting or disconnecting battery clamps.
- Connect the battery terminal not connected to the chassis first, then to the chassis remote from the battery and fuel line.
- Ensure cables do not jam or contact hot surfaces or sharp edges.
- Never attempt to charge non-rechargeable, frozen, or damaged batteries.
- If using the SUPPLY program, the spark protection is disabled, so take precautions against sparks near the battery.
Try it with your setup
How long it takes to charge
At 10 A into a 12 V bank, hours on shore power from 20 % to full.
| 100 Ah bank | 8.8 h |
| 200 Ah bank | 17.7 h |
| 300 Ah bank | 26.5 h |
| — |
Datasheet charge current, charge losses and the absorption phase included.
Fine-tune in the charge time calculator →Wiring it in
Current, fuse and cable size for the MXS 10 12V 10A Battery Charger and Maintainer at full rated power.
Charger → battery
DC output · 12 V| Cable run (one way) | Cable | Voltage drop |
|---|---|---|
| 1 m | 1.5 mm² · 14 AWG | 2 % |
| 2 m | 2.5 mm² · 13 AWG | 2.4 % |
| 3 m | 4 mm² · 12 AWG | 2.2 % |
| 5 m | 6 mm² · 10 AWG | 2.5 % |
Copper cable at 20 °C, positive and negative conductor, at most 3 % voltage drop. The cable is always rated for the fuse that protects it, and the fuse is sized at 125 % of the current. If the manufacturer manual specifies a fuse or cable, follow the manual.
Technical data
Alternatives

- Charge current
- 10 A
- Input
- 230 V AC
- Output
- 12 V DC

- Charge current
- 20 A
- PV input
- up to 100 V
- Output
- 12 V DC

- Charge current
- 20 A
- Input
- 230 V AC
- Output
- 12 V DC
- Charge current
- 5 A
- Input
- 230 V AC
- Output
- 12 V DC
Ratings & reviews
No ratings yet — be the first to rate this component.
Drop the MXS 10 12V 10A Battery Charger and Maintainer into your wiring diagram
VoltPlan sizes the cables, picks the fuses and checks the voltages for every component you connect around it.